NYSP-Z24 Rf Admittance Level Meter
The NYSP-Z24 Rf admittance level meter is based on the principle of
radio frequency admittance level measurement products
continuously.The product has high stability, high sensitivity and
wide applications, etc.Compared with the traditional capacitive
material level meter, the use of modular design, can be concise and
easily realize the instrument set, once set, can be normal use and
free maintenance for life.Enables users to intuitive understanding
of the running status of equipment, and deal with the problems in
time, in the complex industrial occasions as well as safe and
reliable.
Rf Admittance Level Meter Technical Parameter
| Applications | Ultra-high insulation solid |
| Probe type | Ultra-high insulation solid |
| Measuring Range | 0~30m |
| Process temperature | -40～250℃ |
| Ambient temperature | -40 ℃ ~ + 70 ℃ |
| Storage temperature | -20 ℃ ~ + 65 ℃ |
| Process pressure | -0.1～1.6MPa |
| Power supply | (13-35)vDC |
| Signal output | 4...20mA/HART/RS485/Modbus... |
| Process connection | Thread/Flange(selective) |
| Protection class | IP67 |
| Explosion-proof grade | ExiaⅡCT6(selective) |
| Delay: | 0 ~ 30 s adjustable |
※ Note: Products can be customized according to the specific requirements of users!
Sensor component installation
The installation position of the sensor element (probe) is usually
determined by the opening position of the container, but it should
not be installed in the feed stream. When there is no suitable
position inside the container, an outer arm or cylinder can be
considered for installation.
When installing the side wall of the sensor, the protective
electrode should enter the container and pass through the hanging
material of the side wall, so please pay attention to the length of
the protective electrode when selecting the type.
To ensure the normal and accurate operation of the equipment,
please follow the following steps to install:
A. In the case of insulating sensors, the installation must be very
careful, because in this case, there is A risk of damaging the
insulation of the probe, especially the thin capacitive probe.
B. The sensing element shall not be installed in such a way that
the filling nozzle or slot will directly flow into the material. If
this is not possible, install a partition between the probe and the
fill.
C. Do not disassemble the sensor or loosen the mounting seal cover.
D. Tighten the sensor with the flat part of the wrench.
E. The shield must pass through the tank wall when the probe is
installed.
Be careful:
Do not use one-component vulcanized sealants at room temperature
for probes or instrument housings, which often contain acetic acid
and will corrode circuit elements. A special two-component sealant
(non-corrosive) should be used. Consult the manufacturer for the
specific two-component sealant.
